* Click or Tap to Activate Item *
This re-engineered Dual Touring Saddle provides you and a passenger with sculpted seating and long-range comfort. Our generously contoured platforms provide better weight distribution to eliminate hot spots and give long range support. Our STANDARD Dual Touring Saddle is designed to fit the lowest section of the Road King chassis and put you in the Sweet spot, but for most people requires a change to handlebars with more pull-back (like the Flanders "Corbin Bend"). This CLOSE version shown here is designed closer to the bars so a handlebar change isn't required, but still provides a more correct seating posture on the bike for better balance and control.

Corbin's Dual Tour accepts two removable rider's backrests! Each backrest is fully adjustable for a tailored fit to rider posture. Dual Touring Saddle will work with factory luggage rack on the rear if you prefer and we even offer a coordinated pad to complete the look. In the front we have engineered the backrest to fold down to make it easier to mount the bike. This special hardware (internal to the saddle) also allows the backrest position fore and aft to be adjusted to your profile. Naturally, you can use a single backrest that transfers front to back as needed or use two backrests for full time use.

For the ultimate in luxury, we have built electric seat heaters into our Dual Touring saddle design. A single switch controls the heat for both the rider and passenger positions. The switch is conveniently located along the left side of the saddle so you can reach it without taking your hand off the throttle. The two-position switch allows you to select a heat level depending on conditions. The level of heat is controlled automatically by a thermostat built into the control unit. This setup is very simple to install into your Road King wiring.

This saddle also accepts our chrome "V-rail" for an added nostalgic touch, but not if you are using a luggage rack or sissy bar. Show quality chrome plating provides a nice touch of class. V-rail mounts directly to the Corbin saddle for simple installation that does not require drilling or brackets. To simplify mounting the saddle on your bike and provide a nice clean look, we also offer a chromed, billet thumbscrew. Available in either 1/4" x 20 or 1/4" x 28 thread sizes, our thumbscrew gives tool-free installation of your new saddle.

We use genuine leather in all of our seat models to provide a luxurious ride that breathes with your body. A wide range of leather options is available for a custom look to suit your taste. Take good care of your leather seat with a quality conditioner like Corbin's Saddle Cream. You seat will look nice for years and show character just like your leather jacket.